Dodge caravan remote starter install

For the basic install, only 9 wire connections to the van will be required including the optional Horn connection. The bypass module will control the door locks, both power sliding doors and factory alarm. Remove the drivers lower dash panel by removing three Torx T screws, one at the side and two at the bottom edge. Remove the knee plate by removing four T screws marked. Lift the plate up slightly and remove.

Here is a picture of the Ignition Harness connections. Harness continues to the right, to the back of the ignition switch. I've had really good results with Avital, Ultra Start and Compustar system on these mini-vans. I have never used a Prostart product, not too available in my area. I've also had great results with iDatalink and Fortin modules. I usually go W2W mode, too. Close Menu.

Car Security. Ohm's Law Calculators. Relay Diagrams. Subwoofer Wiring. Vehicle Wiring. Recent Topics. Site Search. Site Menu. Advanced Search. Members Search Register Login. Joined: January 30, Always verify all wires, wire colors and diagrams before applying any information found here to your Dodge Grand Caravan. If you would like to help the Modified Life community by adding any missing Dodge Grand Caravan information or adding a new remote car starter wiring schematic to our resource, please feel free and post it at the bottom of this page.

Your email address will not be published. Leave a Reply Cancel reply Your email address will not be published. Follow Us. Copyright by ModifiedLife.